This Dicktator Standard system is suited for Hall-Effect Distributors or single trigger per revolution/ event engines and not Multi-Tooth Trigger Wheels.
Product in Stock
Warning: Last items in stock!
This Dicktator engine management system comes complete with a Harness, Relay, instructions and Software CD.
It is suited for Hall Effect Distributor or single trigger per revolution engines and not Multi-Tooth Trigger Wheels.
This Box can only run a single coil with distrutor or Magnetic Pickup provided it is a single trigger per revolution pickup.
You may require a MAG Sine to Square Wave Convertor if you use a Magnetic Pickup Dicktator Engine Management System
StandardStandard ECU Specifications:
Suitable for any single trigger per event engine.
1 to 12 cylinders are supported but 3 is excluded.
Fuel control adjustable in 1,5,10,Standard,250 micro second increments.
Fully interpolated RPM and load sites.
Load sensing BT map sensor or T.P.S.
Load range 3 BAR map sensor: -100KPA to 200KPA.
Water, air temperature and T.P.S sensor can be calibrated.
Battery voltage compensation.
Adjustable start prime.
Twin injector drivers.
Single ignition driver suitable for intelligent or dumb igniters.
Coil charge time adjustable.
Two wire idle motor control.
Fuel pump control.
Real time programming .
User friendly software.
1 General purpose output.
High speed data logging to PC at up to 60 samples per second.
Selectable rev limiting through fuel cut or spark cut.
Standard ECU box contents:
1 x Dicktator Standard ECU.
1 x Dicktator universal cabling kit.
1 x Dicktator 3 pin relay.
1 x Dicktator software CD.
1 x Dicktator wiring diagram.
Select a row below to filter reviews.
No customer reviews for the moment.
Aftermarket TP100 Ignition Module of High...
A Universal Super-Sequential Atmospheric Dump/...
This Dicktator Ignition Module is of High...
Samco Vacuum Tubing for engine bays - 4mm Diameter
38mm Wastegate locally manufactured by Xcell...
Converter used for converting Sine waveforms to...